Labeling of Proteins in Solution (S9107)

Overview

Dissolve the vial of SNAP-Cell Fluorescein substrate (50 nmol) in 17 μ l of DMSO to yield a stock solution of 3 mM SNAP-tag substrate. Mix for 10 minutes until all the SNAP-tag substrate is dissolved.

Protocol

  1. Prepare a protein solution containing up to 20 μM SNAP-tag fusion protein to be labeled in an appropriate buffer containing at least 1 mM DTT.
  2. Add 3 mM SNAP-tag substrate solution to a total volume of 1% of the volume of the protein solution. Carefully pipette the material up and down to mix, and vortex briefly.
  3. Incubate for 1 hour at 25°C in the dark. Alternatively incubate overnight at 4°C in the dark.
    Removal of Unreacted Substrate (optional) 

    After the labeling reaction you may wish to separate the nonreacted substrate from the labeled SNAP-tag fusion protein. You can use gel filtration as well as dialysis. Please refer to the vendor’s instructions for the separation tools you are using. 

    Notes for Labeling in Solution
    We recommend the routine addition of 1 mM DTT to all buffers for used for handling, labeling and storage of the SNAP-tag. The stability of the SNAP-tag is improved in the presence of reducing agents; however it can also be labeled in their absence.
    SNAP-tag fusion proteins can be purified before labeling, but the labeling reaction also works in non-purified protein solutions (including cell lysates). 

    Troubleshooting for Labeling in Solution 

    Labeling reaction
    If solubility problems occur with your SNAP-tag fusion protein, we recommend testing a range of pH (pH 5.0–pH 10.0) and ionic strengths. The salt concentration may also need to be optimized for your particular fusion protein (50–250 mM). 

    If stickiness of the fusion protein is a problem we recommend adding Tween 20 at a final concentration of 0.05% to 0.1%. The SNAP-tag activity is not affected by this concentration of Tween 20. 

    If exhaustive labeling of a protein sample is not achieved using the recommended conditions, try the following protocol modifications: Double the incubation time to two hours total at 25°C or to 24 hours at 4°C; or halve the volume of protein solution labeled (50 µl of a solution containing up to 20 µM SNAP-tag fusion protein). Both approaches may be combined. If you still have poor labeling results, we recommend checking the activity of the SNAP-tag using SNAP-Vista. 

    If your fusion protein is particularly sensitive to degradation or to loss of activity, you can try reducing the labeling time or decreasing the labeling temperature. If you label at 4°C we recommend overnight incubation.