Home Protocols Peptide-Carrier Kit Protocol I: Western Blotting

Peptide-Carrier Kit Protocol I: Western Blotting

Introduction

This kit provides carrier protein (0.2 mg/ml) for 50 ligation reactions (at least 250 lanes) for Western blot analysis (Protocol I). The extent of ligation is typically 75-90% when a final peptide concentration of 0.5 mM is used. It is not necessary to run Coomassie Blue stained SDS-PAGE unless you wish to check the extent of ligation.

Note: Please refer to Table 1 for a list of reagents that may affect the extent of ligation.

Protocol

  1. Dissolve your peptide in water to a concentration of 1 mM.
  2. Thaw the carrier protein at room temperature.
  3. Mix the following (in order):
  4. Incubate at room temperature for 15-60 minutes or at 4°C overnight.
  5. Add 12.5 µl of 3X SDS Sample Buffer.
  6. Heat at 95°C for 5 minutes.
  7. Load 5-10 µl/lane (~ 25-50 ng) for Western blotting.